FlySky/Turnigy FS-iA6B receiver for FS-i6 and FS-i10 transmittersĨ channels via serial currently supported.When jumper is in place, it uses 28ms frame and channels 1-12 are available Without jumper this converter cable uses 21ms frame size (Channels 1-8). All FrSky S.Bus enabled devices when connected with S.Bus CPPM converter cable.FrSky X4R and FrSky X4RSB when flashed with CPPM firmware and bound with jumper between signal pins 2 and 3.FrSky D8R-XP 8ch telemetry receiver, or CPPM and RSSI enabled receiver.R615X Spektrum/JR DSM2/DSMX Compatible 6Ch 2.4GHz Receiver w/CPPM.PPM is sometimes known as PPM SUM or CPPM.ġ2 channels via a single input pin, not as accurate or jitter free as methods that use serial communications, but readily available. On some platforms using parallel input will disable the use of serial portsĪnd SoftSerial making it hard to use telemetry or GPS features. Parallel PWM ReceiversĨ channel support, 1 channel per input pin. Some new FC's do not support parallel PWM. This is due to the amount of IO pins parallel PWM based receivers use. Avoid Parallel PWM recievers (1 wire per channel). A receiver is used to receive radio control signals from your transmitter and convert them into signals that the flight controller can understand.Īs of 2016 the recommendation for new purchases is a Serial or PPM based receiver.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |